Now that my @Prusa3D MK3S+ is here and printing happily, I need some new filament! Recommendations of 1.75mm filament (besides Prusament, because I already know it is good)?
4
0
0
1
Replying to @spotfoss @Prusa3D
Recently I've used lots of Duramic and Snolabs PETG and been satisfied. (I rarely print with PLA.) Duramic typically comes dry; I once have measured a drop of 1g registered after hours of drying which isn't bad. I'll print it without drying now if I'm in a hurry. 1/

4:57 PM ยท Apr 11, 2021

1
0
0
1
Duramic comes in an aluminized bag. Snolabs comes in clear (PE?). Snolabs I've lost 0-2g of weight after drying, so not too wet but not quite as dry as Duramic so far. Still good enough to print without drying in a pinch. 2/
1
0
0
0
I did order one set of Amazon Basics PETG, each roll of which has lost 2-3g of water when dried, and the shrinkwrap wasn't an obviously sealed bag, so I wouldn't use it without drying first.
3
0
0
0