Misread my spreadsheet for remaining filament on the spool in the drybox (looked at gross weight not net). Now accidentally staying up late waiting to live-splice the replacement spool in when I run out, because I didn't figure this out quickly enough to just start over.
1
0
0
1
Then after patiently waiting I got distracted maintaining my calendar and missed the end going in so was printing air for a bit before I got the new filament feeding. Fortunately this is inner layers and I think it will come out OK. ๐Ÿคž

2:33 AM ยท Jun 21, 2021

1
0
0
6
Replying to @mcdanlj
I have never managed to recover from that. You're deft!
2
0
0
1
I was printing a set of Penrose kites and darts. Two of the tiles, one of each, look a little ugly and I'll want to reprint. But no giant plastic blob. I'll file that under "success" ๐Ÿ˜
1
0
0
1